This is the last of the cards made with 1/2 of the Simply Scrappin' Sunshine Garden Kit. All of these cards are 4" x 4".
Here's a helpful hint. Cut one end of the strip section at 3 3/4". That way you can just pull whatever piece you need off the liner and put it in place. No fuss, no muss.
Place brads in the center of the flowers and pop the flower up using Stampin' Dimensionals. This took a bit of time because you have to cut the dimensionals into itty bitty pieces.
The piece of DSP measures 4" x 3 3/4". Make sure you use the Scallop Border Punch on the 3 3/4" side. That way it will fit perfectly on your card.
The little leaf was taken from inside one of the big leaves. Gotta' use ALL the pieces!
I used the Trio Flower Punch to accent this card.
There is a special way to cut your card stock to get the most out of it. I hope this makes sense.
On your 12" x 12" card stock cut a piece 3" x 12". Fold this in half and this will be your 3" x 6" card.
You now have a piece of card stock that measures 9" x 12". Cut this piece to measure 8" x 12". Save the inch wide piece you just cut off. You can use it for trim, cutting or punching out accents or using it as a mat.
You now have a piece of card stock that measures 8" x 12". Cut this piece on the 12" side at 4" and 8". This will give you 3 pieces of 4" x 8" pieces. Fold these in half and you have 3 - 4" x 4" cards!
I know that some of you are a visual learning. If you need to see a picture, let me know. I'll try and get one for you.
Hope you enjoyed what you can make out of 1/2 a Simply Scrappin' Kit. Thanks for coming by.
Comments